ユーザーマニュアル Seagate 換気フード 1080Sl [14/28 ページ]

Seagate 換気フード 1080SL

Configuring the drive and computer

Once the drive is physically installed, the drive and computer

must be configured to work with each other. This involves parti-

tioning and formatting the drive and may require a special device

driver or installation software depending on the operating system

you are using and your SCSI adapter. Refer to your SCSI

adapter’s documentation for specific information on how to con-

figure your drive.

This guide describes a typical configuration for a PC using DOS

and one or two SCSI drives only.

System setup configuration

Required materials:

• A bootable diskette with the Format and FDISK command

If you are replacing the ATA (IDE) drive or drives in your computer

with SCSI, you must reset the drive-type configuration listed in

System Setup to

Not Installed

1. Turn the computer on.

2. Enter the System Setup routine. (Refer to your computer’s

user guide. System Setup may be called Setup, BIOS Setup

or CMOS Setup.)

3. Find the hard disc configuration in the System Setup screen.

4. Change the drive-type status to

Not Installed

5. Save the changes and exit System Setup.

Low-level formatting

Your drive was low-level formatted at the factory to 512 bytes per

sector. You do not need to low-level format it again. If you choose

12 Medalist 1080sl SCSI Installation Guide, August 1995