ユーザーマニュアル Garmin コンピューターモニター 906-2000-00 [27/38 ページ]

Garmin コンピューターモニター 906-2000-00

Heading Hold

Boat Path

Change Heading with Zigzags

If you program the Idle/Resume button for Zigzags (other), then when you press the Idle/Resume

button the pilot will begin to zigzag about the heading you were on when you pressed the button. The

zigzag angle and period are both programmable. An example zigzag path is shown in the figure below.

Automatic idle and resume is accomplished by pressing the Idle/Resume button. If the throttle is set

higher than idle, the Idle/ Resume function will take the engine to idle. If the throttle is sitting in the

idle position, the Idle/Resume function will return the throttle to the last "above idle" position. The

Idle/Resume button must be programmed to perform Idle/Resume and not MOB or Zigzags.

Idle/Resume

Increase throttle by pressing the Up Arrow button. Decrease throttle by pressing the Down Arrow

button. The electric throttle runs in parallel with the tiller throttle, this means that you can't reduce

the RPM with the electric throttle if the tiller throttle is set high. It is best to always run with the tiller

throttle set to idle. Be careful to set the electric throttle and tiller throttle to closed position before startin

your outboard.

Throttle Up/Down

Idle/Resume Feature

Change Heading Using Zig-Zags